Arduino UNO R3

750.00 675.00

This Arduino Uno R3 board features the ATmega 328P and the new ATmega16u2 for programming via USB. The new Atmega16u2 allows for more memory and faster transfers when you program your device.

Each Arduino Uno R3 board comes with USB cable and works great with HamShield. Remember to buy a nice power supply, as HamShield will use a lot of power.

Category: Tags: ,


Arduino/Genuino Uno is a microcontroller board based on the ATmega328P. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worring too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

Microcontroller ATmega328P
Operating Voltage 5V
Input Voltage (recommended) 7-12V
Input Voltage (limit) 6-20V
Digital I/O Pins 14 (of which 6 provide PWM output)
PWM Digital I/O Pins 6
Analog Input Pins 6
DC Current per I/O Pin 20 mA
DC Current for 3.3V Pin 50 mA
Flash Memory 32 KB (ATmega328P)
of which 0.5 KB used by bootloader
SRAM 2 KB (ATmega328P)
EEPROM 1 KB (ATmega328P)
Clock Speed 16 MHz
Length 68.6 mm
Width 53.4 mm
Weight 25 g

Additional information

Weight 25 g
Dimensions 6.8 x 5.3 cm


There are no reviews yet.

Be the first to review “Arduino UNO R3”

Your email address will not be published. Required fields are marked *

two × one =